nkk switches ? email: sales@nkkswitches.com ? phone (480) 991-0942 ? fax (480) 998-1435 ? www.nkkswitches.com 03-07 miniature slides for high frequency series fs general specifcations distinctive characteristics for high frequency (dc through 1ghz): isolation 40db minimum at 1ghz. insertion loss 0.5db maximum at 1ghz. impedance 75 ohms innovative alternative to relay products highly reliable, self-cleaning twin contact mechanism with gold plating long total travel of .138 (3.5mm) for highly visible actuator position distinct audible and tactile feedback during actuation suited to high frequency applications (90mhz to 1ghz) such as catv and communication equipment actual size with tall actuator electrical capacity (resistive load) logic le vel: 0.4va maximum @ 28v ac/dc maximum (applicable range 0.1ma ~ 0.1a @ 20mv ~ 28v) note: find additional explanation of operating range in supplement section. rf ratings impedance: 75 ohms insertion loss: 0.5db maximum @ 1ghz isolation: 40db minimum @ 1ghz other ratings contact resistance: 20 0 milliohms maximum insulation resistance: 2 50 megohms minimum @ 500v dc dielectric strength: 500v ac minimum for 1 minute minimum mechanical life: 1,000 operations minimum electrical life: 1,000 operations minimum contact timing: nonshorting (break-before-make) total travel: .138 (3.5mm) environmental data operating temp range: C30c through +85c (C22f through +185f) humidity: 90 ~ 95% humidity for 240 hours @ 40c (104f) vibration: 10 ~ 55hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 5 minutes; 3 right angled directions for 2 hours shock: 50g (490m/s 2 ) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) installation soldering time & temp: wave soldering: see profle a in supplement section. manual soldering: see profle a in supplement section. cleaning: these devices are not process sealed. hand clean locally using alcohol based solution.
nkk switches ? email: sales@nkkswitches.com ? phone (480) 991-0942 ? fax (480) 998-1435 ? www.nkkswitches.com 03-07 miniature slides for high frequency series fs terminals p straight pc pole 2 dpdt typical switch ordering example 2 a fs short actuator dpdt on-none-on circuit straight pc terminals slide position connected terminals throw & schematics pole model left center right left center right note: terminal numbers are not actually on the switch. dp fs22 on none on 2-1 5-4 na 2-3 5-6 dpdt circuit 2 on none on 2 description for typical ordering example FS22AAP pole & circuit a actuators a short (.291 or 7.4mm) b tall (.488 or 12.4mm) frequency band a dc through 1ghz p frequency band dc through 1ghz 1 3 4 6 2 5 (com )
nkk switches ? email: sales@nkkswitches.com ? phone (480) 991-0942 ? fax (480) 998-1435 ? www.nkkswitches.com 03-07 miniature slides for high frequency series fs high frequency performance note: the data above ref ects the conditions using the fs switch on a test pcb with two coaxial connectors. high frequency applications require external connection on the pcb. contact factory for details. isolation >40db @ 1ghz (higher value is better) insertion loss <0.5db @ 1ghz (lower value is better) standing wave ration or impedance matching standing wave = ratio between highest voltage & lowest voltage (must always be more than 1) rf connection options t = terminator typical switch dimensions short & tall actuators fs22abp actuator in left position. a = amplif er or other device = circuit trace option 1 option 2 option 3 direction of actuation direction of actuation direction of actuation 10mhz 500mhz 1ghz db 90 30 40 50 60 70 80 isolation: greater than 40db @ 1ghz out 2 a in out 5 6 2 3 4 1 (1.75) ty p .069 1 2 3 (2.0) ty p .079 4 5 6 (1.6) dia ty p .063 (7.85) ty p .309 (0.8) dia ty p .031 (1.2) dia ty p .047 (3.5) ty p .138 10mhz 500mhz 1ghz db 0.6 0 0.1 0.2 0.3 0.4 0.5 inser tion loss: less than 0.5db @ 1ghz 10mhz 500mhz 1ghz vswr (v oltage standing w ave ratio): 1:1 @ 1ghz v s w r 1.6 1 1.1 1.2 1.3 1.4 1.5 (3.0) sq .118 (7.4) .291 (17.0) .669 part no. (12.4) .488 (3.5) t ravel .138 (9.6) .378 (2.9) .114 (0.3) .012 (1.75) ty p .069 (3.5) ty p .138 (15.7) .618 4 1 2 3 5 6 (0.3) ty p .012 (4.0) .157 (0.6) ty p .024 (3.5) t ravel .138 (7.4) .291 in out 5 6 2 3 4 1 t a in out 5 6 2 3 4 1
|
